Garmin G1000 NXi Reference Manual page 246

Appendix
Updating Databases:
With the system OFF, remove an SD Card from the bottom SD card slot of the
1)
MFD.
2) Download and
3) Put the SD Card in the bottom SD card slot of the MFD.
4) Turn the system ON.
ENT
5) Press the
acknowledge the startup screen.
6) Turn the large
7) Turn the small
8) Monitor the Sync Status on the 'Aux-Databases' Page. Wait for all
databases to complete syncing, indicated by 'Sync Complete' being
displayed. A cyan double-arrow will appear between the Standby and
Active columns to show which Standby databases will be transferred to
Active at the next power cycle.
9) Verify the correct database cycle information is shown in the Standby
column.
10) Remove power from the system.
11) Remove the SD card from the bottom slot of the MFD if desired.
12) Apply power to the system.
ENT
13) Press the
acknowledge the startup screen.
14) Turn the large
15) Turn the small
16) Verify the standby databases transferred and are now in the Active column.
17) To manually activate any databases that did not transfer to the active
column:
a) Push the
selected.
b) Turn the small
c) Press the
the standby database will become active.
Or:
220
Garmin G1000 NXi Cockpit Reference Guide for the Cessna NAV III
install the databases on an SD card.
Key or the right-most softkey on MFD display to
FMS
Knob and select Aux.
FMS
Knob and select Databases.
Key or the right-most softkey on MFD display to
FMS
Knob and select Aux
FMS
Knob and select the Databases.
FMS
Knob. The first database title on the screen will be
FMS
Knob as necessary to select the database title.
ENT
Key. A cyan double-sided arrow will appear indicating
.
190-02178-02 Rev. A