Garmin G1000 NXi Reference Manual page 152

Hazard Avoidance
4) If the optional TAS is installed, ensure the TAS STBY Softkey is enabled.
5) Press the Test Softkey.
Or:
a) Press the MENU Key.
b) Turn the small FMS Knob to highlight 'Test Mode'.
c) Press the ENT Key.
6) Self test takes approximately ten seconds to complete. When completed
successfully, traffic symbols are displayed and a voice alert "Traffic System
Test" is heard. If the self test passes the traffic system will revert to
Standby Mode, and no failure annunciators will be displayed.
Changing the Altitude Range
1) On the 'Map - Traffic Map' Page, press the ALT Mode Softkey.
2) Select one of the following softkeys:
• Above: Displays Other Non-Threat and proximity traffic from 9900 feet
above the aircraft to 2700 feet below the aircraft. Typically used during
climb phase of flight.
• Normal: Displays Other Non-Threat and proximity traffic from 2700 feet
above the aircraft to 2700 feet below the aircraft. Typically used during
enroute phase of flight.
• Below: Displays Other Non-Threat and proximity traffic from 2700 feet
above the aircraft to 9900 feet below the aircraft. Typically used during
descent phase of flight.
• UNREST (unrestricted): All traffic is displayed from 9900 feet above and
9900 feet below the aircraft.
3) To return to the 'Map - Traffic Map' Page, select the Back Softkey.
Enabling/Disabling the Motion Vector Display
1) Select the 'Map - Traffic Map' Page.
2) Press the Motion Softkey.
3) Press one of the following softkeys:
• Absolute: Displays the motion vector pointing in the absolute direction.
• Relative: Displays the motion vector relative to own aircraft
• Off: Disables the display of the motion vector.
126
Garmin G1000 NXi Cockpit Reference Guide for the Cessna NAV III
190-02178-02 Rev. A