Entering Or Modifying A Baro Qfe Altitude Constraint; Modifying The Vs Tgt And Fpa - Garmin G1000 NXi Reference Manual

Flight Management
4) Select 'REVERT' and press the
navigation database value.
FMS
5) Push the

ENTERING OR MODIFYING A BARO QFE ALTITUDE CONSTRAINT

WARNING:
when navigating to a waypoint that contains a QNE (flight level) altitude
constraint.
WARNING:
clearance from the reference airfield when operating in IMC while conducting
QFE procedures.
1) With Baro QFE enabled, press the
– Active Flight Plan' Page.
FMS
2) Push the
waypoint altitude constraint ('ALT').
3) Turn the small
FMS
use the
modifying an existing Baro QFE altitude constraint, turning the small
Knob displays the existing constraint in MSL in the entry field. If adding a
new altitude constraint, turning the small
the entry field.
ENT
4) Press the
ENT
the Key to accept the altitude constraint. The constraint is shown in
parenthesis indicating it is based on the Baro QFE setting.

MODIFYING THE VS TGT AND FPA

FPL
1) Press the
Page.
VNV Prof
2) Press the
VNV Profile Window', and press the
the 'Active VNV Profile' Box.
FMS
3) Turn the
FMS
4) Push the
80
Garmin G1000 NXi Cockpit Reference Guide for the Cessna NAV III
ENT
Knob to remove the flashing cursor.
Do not fly QFE procedures above the Transition Altitude or
Always fly a procedure that provides terrain and obstacle
Knob, and turn the large
FMS
Knob to begin entry of the altitude constraint, and
Knobs to enter the constraint in reference to Baro QFE. If
Key. Turn the small
Key for the MFD to display the 'FPL – Active Flight Plan'
Softkey; or press the
Knobs as needed to edit the values.
Knob to remove the flashing cursor.
Key. The altitude is changed to the
FPL
Key for the MFD to display the 'FPL
FMS
Knob to highlight the desired
FMS
Knob displays '00000FT' in
FMS
Knob to highlight 'QFE' and press
MENU
Key, highlight 'Select
ENT
Key. The cursor is now located in
FMS
190-02178-02 Rev. A