Setting The Baro Qfe - Garmin G1000 NXi Reference Manual

SETTING THE BARO QFE

Setting BARO QFE while on the ground:
1) Set the appropriate QFE BARO setting on the PFD.
FMS
2) Use the
FMS
3) Push the
4) Turn the large
5) Use the small
ENT
Key to accept.
6) If 'Manual' was selected, use the
the departure airport in the 'ELEV' field and press the
7) If 'FMS ORIG' was selected, the field elevation of the selected departure
airport/runway from the flight plan will be shown in the 'BARO QFE' Box.
Verify this information is correct.
8) The 'On/Off' Field will automatically highlight, turn the small
change the selection from 'Off' to 'On'.
FMS
9) Push the
Change the BARO setting to STD BARO to disable BARO QFE.
Setting BARO QFE while in flight:
1) Set the BARO setting to STD BARO on the PFD.
FMS
2) Use the
FMS
3) Push the
4) Turn the large
5) Use the small
ENT
Key to accept.
6) If 'Manual' was selected, use the
the destination airport in the 'ELEV' field and press the
7) If 'FMS DEST' was selected, the field elevation of the selected destination
airport/runway from the flight plan will be shown in the BARO QFE Box.
Verify this information is correct.
8) The 'On/Off' Field will automatically highlight, turn the small
change the selection from 'Off' to 'On'.
190-02178-02 Rev. A
Knob to select the 'Aux - System Setup 1' Page on the MFD.
Knob to activate the cursor.
FMS
Knob to select the 'REF' field in the 'BARO QFE' Box.
FMS
Knob to select 'Manual' or 'FMS ORIG', and press the
Knob to deactivate the cursor. QFE mode is now active.
Knob to select the 'Aux - System Setup 1' Page on the MFD.
Knob to activate the cursor.
FMS
Knob to select the 'REF' field in the BARO QFE Box.
FMS
Knob to select 'Manual' or 'FMS DEST', and press the
Garmin G1000 NXi Cockpit Reference Guide for the Cessna NAV III
Flight Instruments
FMS
Knobs to enter the field elevation of
FMS
Knobs to enter the field elevation of
ENT
Key.
FMS
Knob to
ENT
Key.
FMS
Knob to
3