Garmin G1000 NXi Reference Manual page 221

Message
DB MISMATCH – Terrain database
mismatch.
DIG GMA1 MANIFEST – DIG GMA
1 software mismatch, communication
halted.
DME CHECK RANGE – DME range
disagreement. Check position sensors.
FAILED PATH – A data path has failed. A data path connected to the GDU or the GIA
FPL TRUNC – Flight plan has been
truncated.
FPL WPT LOCK – Flight plan waypoint
is locked.
G/S1 FAIL – G/S1 is inoperative.
190-02178-02 Rev. A
Comments
The PFD and MFD have different terrain
database versions or types installed. Check the
Aux-System Status Page to determine versions
or regions. Also, check the Aux-System Status
Page for a database synchronization function
not completed. After synchronization is
complete, power must be turned off, then on.
The digital audio controller has incorrect
software installed. The system should be
serviced.
A failure or disagreement has been detected in
a DME receiver. Check position sensors.
63W has failed.
This occurs when a newly installed navigation
database eliminates an obsolete approach
or arrival used by a stored flight plan. The
obsolete procedure is removed from the flight
plan. Update flight plan with current arrival or
approach.
Upon power-on, the system detects that a
stored flight plan waypoint is locked. This
occurs when an navigation database update
eliminates an obsolete waypoint. The flight
plan cannot find the specified waypoint and
flags this message. This can also occur with
user waypoints in a flight plan that is deleted.
Remove the waypoint from the flight plan if it
no longer exists in any database,
OR
update the waypoint name/identifier to reflect
the new information.
A failure has been detected in glideslope
receiver 1. The system should be serviced.
Garmin G1000 NXi Cockpit Reference Guide for the Cessna NAV III
Annunciations & Alerts
195