Garmin G1000 NXi Reference Manual page 249

NOTE: The database updates may now be continued from any MFD page,
however, the update windows shown in these instructions will not be shown
on the 'Aux - Databases' Page. Use the proceeding instructions in this section
to update databases from the 'Aux - Databases' Page.
10) Press the Update Softkey when the window appears. (Pressing the View
Softkey will allow database updates to be viewed from the 'Aux Databases'
Page, however, the windows shown below will not appear on the 'Aux
Databases' Page. Pressing the Ignore Softkey will postpone the updates
until further action is taken.)
11) If using a device that has not been previously paired with the system, a
password prompt will appear on the mobile device. Enter the password
shown in the 'Password' Field of the 'Aux - Connext Setup' Page.
12) Database update progress may be monitored on the mobile device.
13) When the transfer is complete, a screen will appear.
14) Press the Close Softkey.
15) Remove and reapply power to the system.
16) Press the ENT Key or the right-most softkey on MFD display to
acknowledge the startup screen.
17) Turn the large FMS Knob and select Aux
18) Turn the small FMS Knob and select Databases.
19) Verify that the standby databases transferred and are now in the Active
column.
20) To manually activate any databases that did not transfer to the active
column:
a) Press the FMS Knob. The first database title on the screen will be
selected.
b) Turn the small FMS Knob as necessary to select the database title.
c) Press the ENT Key. A cyan double-sided arrow will appear indicating
that the standby database will become active.
Or:
Press the Menu Key and select 'Swap Stby/Actv' using the small FMS
Knob. Press the ENT Key. A cyan double-sided arrow will appear
indicating that the standby database will become active.
d) Remove and reapply power to the system.
190-02178-02 Rev. A Garmin G1000 NXi Cockpit Reference Guide for the Cessna NAV III
.
Appendix
223