Garmin G1000 NXi Reference Manual page 251

4) On the mobile device, start Garmin Pilot and tap
Database Concierge.
5) Turn the large FMS Knob and select Aux
6) Turn the small FMS Knob and select the Connext Setup.
7) Ensure that Wifi Database Import is enabled in the 'Device' Window (refer
to Additional Features section for instructions to enable Wifi Database
Import).
8) Verify that the mobile device is enabled via Bluetooth in the Bluetooth
settings on the mobile device.
9) In the 'Paired Devices' Window on the 'Connext Setup' Page, ensure the
system is paired with the mobile device in use. (refer to Additional Features
for instructions on connection to a preferred device).
ress the Device Softkey to view databases that are ready to be loaded
10) P
from the mobile device (pressing the
the current Standby and Active databases).
he 'Aux - Databases' Page will show the databases connected to the mobile
11) T
device in place of the active databases on the system. Databases selected to
load to the system will be indicated by a single cyan arrow.
12) Press the Update Softkey.
13) If using a device that has not been previously paired with the system, a
password prompt will appear on the mobile device. Enter the password
shown in the 'Password' Field of the 'Aux - Connext Setup' Page.
14) Database Update status will appear in the 'Status' Window at the top
of the page. Monitor update progress in the 'Status' Window, or on the
mobile device.
15) When all databases have been successfully transferred from the mobile
device and appear in the Standby column, remove and reapply power to the
system.
16) Press the ENT Key or the right-most softkey on MFD display to
acknowledge the startup screen.
17) Turn the large FMS Knob and select Aux.
18) Turn the small FMS Knob and select Databases.
19) Verify that the standby databases transferred and are now in the Active
column.
190-02178-02 Rev. A Garmin G1000 NXi Cockpit Reference Guide for the Cessna NAV III
Home > Connext >
.
Stby/Actv Softkey will again display
Appendix
225