Garmin G1000 NXi Reference Manual page 228

Hide thumbs Also See for G1000 NXi:
Table of Contents

Advertisement

Annunciations & Alerts
Message
NAV1 RMT XFR – NAV1 remote
transfer key is stuck.
NAV1 SERVICE – NAV1 needs service.
Return unit for repair.
NAV2 MANIFEST – NAV2 software
mismatch, communication halted.
NAV2 RMT XFR – NAV2 remote
transfer key is stuck.
NAV2 SERVICE – NAV2 needs service.
Return unit for repair.
NON-MAGNETIC UNITS – Non-
magnetic NAV ANGLE display units are
active.
NON WGS84 WPT – Do not use GPS
for navigation to [xxxx]
PFD1 BACKLIGHT CALIBRATION –
PFD1 calibration lost. Return for repair.
PFD1 CONFIG – PFD1 config error.
Config service req'd.
PFD1 COOLING – PFD1 has poor
cooling. Reducing power usage.
PFD1 DB ERR – PFD1 obstacle
database missing.
202
Garmin G1000 NXi Cockpit Reference Guide for the Cessna NAV III
Comments
The remote NAV1 transfer switch is stuck in the
enabled (or "pressed") state. Press the transfer
switch again to cycle its operation. If the
problem persists, the system should be serviced.
A failure has been detected in the NAV1
receiver. The receiver may still be available. The
system should be serviced.
NAV2 software mismatch. The system should
be serviced.
The remote NAV2 transfer switch is stuck in the
enabled (or "pressed") state. Press the transfer
switch again to cycle its operation. If the
problem persists, the system should be serviced.
A failure has been detected in the NAV2
receiver. The receiver may still be available. The
system should be serviced.
Navigation angle is not set to MAGNETIC at
power-on.
The position of the selected waypoint [xxxx]
is not calculated based on the WGS84 map
reference datum and may be positioned in error
as displayed. Do not use GPS to navigate to the
selected non-WGS84 waypoint..
The PFD1 backlight calibration cannot be found
or is invalid. The system should be serviced.
The PFD configuration settings do not match
backup configuration memory. The system
should be serviced.
The PFD is overheating and is reducing power
consumption by dimming the display. If
problem persists, the system should be serviced.
The obstacle database is present on another
LRU, but is missing on the specified LRU.
190-02178-02 Rev. A

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents