Snmp-Server Enable Traps Ipran Util - Cisco 3825 Software Configuration Manual

snmp-server enable traps ipran util

snmp-server enable traps ipran util
To provide information alarms associated with backhaul utilization via Simple Network Management
Protocol (SNMP) notifications (traps) available on your system, use the snmp-server enable traps
ipran util command in global configuration mode. To disable ipran alarm-gsm notifications, use the no
form of this command.
Syntax Description This command has no arguments or keywords.
Defaults
This command is disabled by default. No notifications are sent.
Command Modes Global configuration
Command History Release
12.4(2)MR1
12.4(9)MR
Examples
The following is an example of the output generated by this command.
Router(config)# snmp-server enable traps ipran util
Related Commands Command
snmp-server enable traps
ipran alarm-gsm
snmp-server enable traps
ipran alarm-umts
snmp-server enable traps
ipran
ipran-mib
backhaul-notify-interval
ipran-mib
threshold-acceptable
ipran-mib
threshold-overloaded
ipran-mib
threshold-warning
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
A-118
snmp-server enable traps ipran util
no snmp-server enable traps ipran util
Modification
This command was introduced.
Support for utilization notification has been removed and the command is
provided only to maintain compatibility.
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
Description
Provides information alarms associated with GSM-Abis interfaces.
Provides information alarms associated with UMTS-Iub interfaces.
Enables all notifications.
Specifies the interval used to calculate the utilization.
Specifies the acceptable level of traffic.
Specifies the amount of traffic that indicates the backhaul is
overloaded.
Specifies the amount of traffic that indicates the backhaul is carrying
traffic sufficient to impact performance, but is not overloaded.
OL-15667-03