Xconnect Logging Redundancy - Cisco 3825 Software Configuration Manual

xconnect logging redundancy

xconnect logging redundancy
To enable system message log (syslog) reporting of the status of the xconnect redundancy group, use the
xconnect logging redundancy command in global configuration mode. To disable syslog reporting of
the status of the xconnect redundancy group, use the no form of this command.
Syntax Description
This command has no arguments or keywords.
Defaults
Syslog reporting of the status of the xconnect redundancy group is disabled.
Command Modes Global configuration
Command History Release
12.0(31)S
12.2(28)SB
12.4(11)T
12.4(16)MR
Usage Guidelines Use this command to enable syslog reporting of the status of the xconnect redundancy group.
Examples
The following example enables syslog reporting of the status of the xconnect redundancy group and
shows the messages that are generated during switchover events:
Router# config t
Router(config)# xconnect logging redundancy
Router(config)# exit
Activating the Primary Member
00:01:07: %XCONNECT-5-REDUNDANCY: Activating primary member 10.55.55.2:1000
Activating the Backup Member:
00:01:05: %XCONNECT-5-REDUNDANCY: Activating secondary member 10.55.55.3:1001
Related Commands Command
xconnect
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
A-136
xconnect logging redundancy
no xconnect logging redundancy
Modification
This command was introduced.
This command was integrated into Cisco IOS Release 12.2(28)SB.
This command was integrated into Cisco IOS Release 12.4(11)T.
This command was integrated into Cisco IOS Release 12.4(16)MR.
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
Description
Binds an Ethernet, 802.1q VLAN, or Frame Relay attachment circuit
to an L2TPv3 PW for xconnect service and enters xconnect
configuration mode.
OL-15667-03