Atm Umts - Cisco 3825 Software Configuration Manual

atm umts

atm umts
To select an ATM interface for Universal Mobile Telecommunications System (UMTS) Iub traffic for
the atm subinterfaces, use the atm umts Sub-Interface configuration command. This command is used
when you want to off load one or more permanent virtual circuit (PVC) traffic packets from a physical
ATM shorthaul so as to go over an alternate backhaul. For each alternate backhaul, you need to create a
logical shorthaul by creating an atm subinterface. Traffic for the PVCs configured under this logical
shorthaul will go through the corresponding alternate backhaul.
Syntax Description
This command has no arguments or keywords.
Command Modes Sub-Interface configuration
Command History Release
12.4(4)MR
Examples
The following example illustrates the use of atm umts command.
Router(config)# interface ATM0/2/0
Router(config-if)# atm umts-iub
Router(config-subif)# atm umts
You can use this command only when the base atm interface is already enabled as atm umts.
Note
Related Commands Command
umts local [ip-address]
umts remote [ip-address]
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
A-4
atm umts
Modification
This command is introduced.
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
Description
This command configures the local IP address for alternate backhaul.
This command configures the remote IP address for alternate
backhaul.
OL-15667-03