Snmp-Server Enable Traps Ipran Alarm-Gsm - Cisco 3825 Software Configuration Manual

snmp-server enable traps ipran alarm-gsm

snmp-server enable traps ipran alarm-gsm
To provide information alarms associated with GSM-Abis interfaces via Simple Network Management
Protocol (SNMP) notifications (traps) available on your system, use the snmp-server enable traps
ipran alarm-gsm command in global configuration mode. To disable ipran alarm-gsm notifications, use
the no form of this command.
This statement controls the generation of the cisco IpRanBackHaulGsmAlarm notification from the
CISCO-IP-RAN-BACKHAUL-MIB.
Syntax Description This command has no arguments or keywords.
Defaults
This command is disabled by default. No notifications are sent.
Command Modes Global configuration
Command History Release
12.4(2)MR1
Examples
The following is an example of the output generated by this command.
Router(config)# snmp-server enable traps ipran alarm-gsm
Related Commands Command
snmp-server enable traps
ipran alarm-umts
snmp-server enable traps
ipran util
snmp-server enable traps
ipran
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
A-116
snmp-server enable traps ipran alarm-gsm
no snmp-server enable traps ipran alarm-gsm
Modification
This command was introduced.
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
Description
Provides information alarms associated with UMTS-Iub interfaces.
Provides information on backhaul utilization.
Enables all notifications.
OL-15667-03