Umts-Iub Set Peering Dscp - Cisco 3825 Software Configuration Manual

umts-iub set peering dscp

umts-iub set peering dscp
To overwrite the interface default value defined in the umts-iub set dscp value and is used to tag the
peering backhaul packet, use the umts-iub set peering dscp Interface configuration command.
Note Use this command when configuring UMTS shorthaul interfaces.
Syntax Description value
Defaults There are no default settings or behaviors.
Command Modes Interface configuration
Command History Release
12.4(4)MR
Examples The following example shows how to configure the parameters:
Router(config)# interface ATM0/2/0
Router(config-if) atm umts-iub
Router(config-if) umts-iub set dscp value
Related Commands Command
umts-iub set dscp
(Interface Configuration mode)
umts-iub set dscp
(ATM-VC Configuration mode)
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
A-130
umts-iub set peering dscp value
A number from 0 to 63 that sets the UMTS-Iub DSCP value.
Modification
This command was introduced.
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
Description
This command sets the description value used as the interface
default description value to tag the backhaul packet including the
peering and data generated from the shorthaul.
This command overwrites the interface default value defined in the
umts-iub set dscp value for UMTS shorthaul interfaces and is used
to tag the backhaul packet generated from traffic from a PVC
OL-15667-03