Cisco 3825 Software Configuration Manual page 261

Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
umts-iub set dscp
To overwrite the interface default value defined in the umts-iub set dscp value for UMTS shorthaul
interfaces and is used to tag the backhaul packet generated from traffic from a PVC, use the umts-iub
set dscp ATM-VC configuration command.
Use this command when configuring PVCs of the UMTS shorthaul interfaces
Note
Syntax Description value
Defaults
There are no default settings or behaviors.
Command Modes ATM-VC configuration
Command History Release
12.4(4)MR
Examples
The following example shows how to configure the remote parameters:
Router(config)# interface ATM0/2/0
Router(config-if)# atm umts-iub
Router(config-if)# umts-iub set dscp value
Router(config-if-atm-vc)# umts-iub set dscp value
Related Commands Command
umts-iub set dscp
(Interface Configuration mode)
umts-iub set peering dscp
OL-15667-03
umts-iub set dscp value
A number from 0 to 63 or hex value that sets the UMTS-Iub DSCP value.
Modification
This command was introduced.
Description
This command sets the description value used as the interface
default description value to tag the backhaul packet including the
peering and data generated from the shorthaul
This command overwrites the interface default value defined in the
umts-iub set dscp value and is used to tag the peering backhaul
packet
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
umts-iub set dscp
A-129