Match Ip Dscp - Cisco 3825 Software Configuration Manual

Mobile wireless edge router
Table of Contents

Advertisement

match ip dscp

match ip dscp
To identify a specific IP differential service code point (DSCP) value as a match criterion, use the match
ip dscp class-map configuration command. To remove a specific IP DSCP value from a class map, use
the no form of this command.
Syntax Description
ip-dscp-value
Defaults
This command has no default behavior or values.
Command Modes
Class-map configuration
Command History
Release
12.0(5)XE
12.0(9)S
12.1(2)T
12.4(4)MR
Usage Guidelines
Up to eight IP DSCP values can be matched in one match statement. For example, if you wanted the IP
DSCP values of 0, 1, 2, 3, 4, 5, 6, or 7 (note that only one of the IP DSCP values must be a successful
match criterion, not all of the specified IP DSCP values), enter the match ip dscp 0 1 2 3 4 5 6 7
command.
This command is used by the class map to identify a specific IP DSCP value marking on a packet. The
ip-dscp-value arguments are used as markings only. The IP DSCP values have no mathematical
significance. For instance, the ip-dscp-value of 2 is not greater than 1. The value simply indicates that a
packet marked with the ip-dscp-value of 2 is different than a packet marked with the ip-dscp-value of 1.
The treatment of these marked packets is defined by the user through the setting of QoS policies in
policy-map class configuration mode.
Examples
The following example shows how to configure the service policy called priority50 and attach service
policy priority50 to an interface. In this example, the class map called ipdscp15 will evaluate all packets
entering interface Gigabit Ethernet 0/0 for an IP DSCP value of 15. If the incoming packet has been
marked with the IP DSCP value of 15, the packet will be treated with a priority level of 55.
Router(config)# class-map ipdscp15
Router(config-cmap)# match ip dscp 15
Router(config-cmap)# exit
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
A-60
match ip dscp ip-dscp-value [ip-dscp-value ip-dscp-value ip-dscp-value ip-dscp-value
ip-dscp-value ip-dscp-value ip-dscp-value]
no match ip dscp ip-dscp-value [ip-dscp-value ip-dscp-value ip-dscp-value ip-dscp-value
ip-dscp-value ip-dscp-value ip-dscp-value]
Specifies the exact value from 0 to 63 used to identify an IP DSCP value.
Modification
This command was introduced.
This command was incorporated.
This command was incorporated.
This command was incorporated.
Appendix A
Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
OL-15667-03

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents