Umts Local - Cisco 3825 Software Configuration Manual

Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference

umts local

To configure local ip address for the atm subinterfaces, use the umts local Sub-Interface configuration
command. This command is used when you want to off load PVC traffic from a physical ATM shorthaul
to an alternate backhaul. For each alternate backhaul, you need to create a logical shorthaul by creating
an atm subinterface. Traffic for the PVCs configured under this logical shorthaul will go through the
corresponding alternate backhaul.
Syntax Description ip-address
Command Modes Sub-Interface configuration
Command History Release
12.4(4)MR
Examples The following example illustrates the use of the umts local command in Sub-Interface command mode.
Router(config)# interface ATM0/2/0
Router(config-if)# atm umts-iub
Router(config-subif)# atm umts
Router(config-subif)# umts local 10.10.10.2 5504
You do not need to input UDP port. The UDP port number will be inherited automatically from the base
Note
atm interface's umts remote [ip-address] [port] port configuration.
Related Commands Command
atm umts
umts remote [ip-address]
OL-15667-03
umts local [ip-address]
The IP address for the entry you wish to establish.
Modification
This command was introduced.
Description
This command enables the UMTS mode for alternate backhaul.
This command configures remote IP address for alternate backhaul.
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
umts local
A-131