Cisco 3825 Software Configuration Manual page 121

Chapter 4 Configuring the Cisco 3825 Mobile Wireless Edge Router in a RAN-O Solution with the Command-Line
ip address 10.10.10.2 255.255.255.255
!
interface Loopback1
description Loopback IP for Unnumbered
ip address 172.168.1.2 255.255.255.252
!
interface Multilink1
description MLPPP IP interface for IP backhaul bundle
ip unnumbered Loopback1
ip tcp header-compression ietf-format
load-interval 30
no keepalive
no cdp enable
ppp pfc local request
ppp pfc remote apply
ppp acfc local request
ppp acfc remote apply
ppp multilink
ppp multilink interleave
ppp multilink group 1
ppp multilink fragment delay 0 1
ppp multilink multiclass
hold-queue 50 out
max-reserved-bandwidth 100
service-policy output llq-policy
ip rtp header-compression ietf-format
!
interface GigabitEthernet0/0
no ip address
shutdown
duplex auto
speed auto
!
interface Serial0/0/0:0
no ip address
no keepalive
description GSM Abis interface
encapsulation gsm-abis
gsm-abis local 172.168.1.2 3334
gsm-abis remote 172.168.1.1 3334
!
interface GigabitEthernet0/1
no ip address
shutdown
duplex auto
speed auto
!
interface Serial0/0/1:0
no ip address
no keepalive
description GSM Abis interface
encapsulation gsm-abis
gsm-abis local 172.168.1.2 3336
gsm-abis remote 172.168.1.1 3336
!
interface Serial0/1/0:0
no ip address
description IP backhaul MLPPP member interface
encapsulation ppp
ppp multilink group 1
max-reserved-bandwidth 100
!
interface ATM0/1/1
no ip address
OL-15667-03
!--- Port numbers must be even
!--- Port numbers must be even
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
Saving Configuration Changes
4-63