Cisco 3825 Software Configuration Manual page 194

mode y-cable
mode y-cable
To access the command mode that allows you to manually control the relays on the voice/WAN interface
card (VWIC) or high-speed WAN interface card (HWIC), use the mode y-cable command in redundancy
configuration mode.
Syntax Description This command has no parameters, it invokes the y-cable mode.
Defaults There are no default settings or behaviors.
Command Modes
Redundancy configuration
Command History Release
12.2(8)MC2
12.2(15)MC1
12.3(11)T
12.4(2)MR
Examples The following example enables y-cable mode:
Router(config)# redundancy
Router(config-r)# mode y-cable
Related Commands Command
standalone
standby use-interface
redundancy
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
A-62
mode y-cable
Modification
This command was introduced.
This command was incorporated.
This command was incorporated.
This command was incorporated.
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
Description
Indicates whether the Cisco 3825 router is being used as a standalone
device and manually sets the relays.
Designates a loopback interface as a health or revertive interface.
Invokes redundancy mode.
OL-15667-03