Class Cem - Cisco 3825 Software Configuration Manual

Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference

class cem

Use the class cem command in the global configuration mode to configure CEM interface parameters in
a class that's applied to CEM interfaces together. This command works in the same manner for CEM
interfaces as pseudowire-class does for xconnect.
Syntax Description class-name
Command Modes
Global configuration
Command History Release
12.4(12)MR2
Usage Guidelines The class cem command allows you to configure CEM interface parameters in a class that's applied to
CEM interfaces together. A class cem command includes the following configuration settings:
•
•
•
Examples
The following example illustrates the use of the class cem command:
Router# config t
Router(config)# class cem mycemclass
Router(config-cem-class)# dejitter-buffer 10
Router(config-cem-class)# sample-rate 2
Router(config-cem-class)# exit
Router(config)# interface cem 0/0/0
Router(config-if)# no ip address
Router(config-if)# cem 0
Router(config-if-cem)# xconnect 10.10.10.10 200 encapsulation mpls
Router(config-if-cem-xconn)# cem class mycemclass
Router(config-if-cem)# exit
Router(config-if)# exit
Router(config)# exit
Related Commands Command
dejitter-buffer
idle-pattern
OL-15667-03
class cem class-name
(Required) The name of a CEM interface parameters class.
Modification
This command was introduced.
dejitter-buffer dejitter in ms
idle-pattern Set 8 bit idle pattern
sample-rate Sample rate (in ms)
Description
Specifies the size of the dejitter-buffer used for the network jitter in
the CEM configuration mode.
Specifies the data pattern to transmit on the T1/E1 when missing
packets are detected on the PWE3 circuit in the CEM configuration
mode.
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
class cem
A-13