Cisco 3825 Software Configuration Manual page 228

show mpls l2transport vc
Release
12.2(17d)SXB
12.2(25)S
12.2(28)SB
12.2(33)SRA
12.4(16)MR
Usage Guidelines If you do not specify any keywords or arguments, the command displays a summary of all the VCs.
Examples The output of the commands varies, depending on the type of Layer 2 packets being transported over the
AToM VCs.
The following sample output shows information about the interfaces and VCs that have been configured
to transport various Layer 2 packets on the router:
Router# show mpls l2transport vc
Local intf
-------------
AT4/0
AT4/0
AT4/0.300
Table A-4
Table A-4
Field
Local intf
Local circuit
Dest address
VC ID
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
A-96
Appendix A
Modification
Support for this command on the Supervisor Engine 2 was extended to Release
12.2 SX.
This command was updated with new output and fields for nonstop forwarding
(NSF), stateful switchover (SSO), and graceful restart (GR) abilities.
This command was implemented on the Cisco 10000 series routers.
Example output was changed for the Cisco 10000 series router, and two fields
(SSO Descriptor and SSM segment/switch IDs) were removed from the output
because they are not supported.
This command was integrated into Cisco IOS Release 12.2(33)SRA.
This command was integrated into Cisco IOS Release 12.4(16)MR.
Local circuit
------------------ --------------- ---------- ----------
ATM AAL5 0/100
ATM AAL5 0/200
ATM AAL5 0/300
describes the significant fields shown in the display.
show mpls l2transport vc Field Descriptions
Description
The interface on the local router that has been enabled to transport Layer 2
packets.
The type and number (if applicable) of the local circuit. The output shown in this
column varies, depending on the transport type:
For ATM cell relay and AAL5, the output shows the VPI/VCI of the PVC.
•
For Ethernet VLANs, the output shows the VLAN number.
•
The IP address of the remote router's interface that is the other end of the VC.
The VC identifier assigned to one of the interfaces on the router.
Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
Dest address VC ID
10.0.0.1 100
10.0.0.1 200
10.0.0.1 300
Status
UP
UP
UP
OL-15667-03