Gsm-Abis Congestion Enable - Cisco 3825 Software Configuration Manual

Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference

gsm-abis congestion enable

The congestion detection algorithm monitors the transmit jitter buffer and sends congestion indicator
signals to the remote when congestion is detected. The remote will suppress all timeslots that are not
defined as critical in an effort to alleviate the congestion. The goal of the congestion detection algorithm
is to save the critical timeslots from loss of data. To enable the congestion detection algorithm, use the
gsm-abis congestion enable Interface configuration command.
Syntax Description This command has no arguments or keywords.
Defaults There are no default settings or behaviors.
Command Modes Interface configuration
Command History Release
12.4(2)MR
Examples The following example shows how to enable the gsm-abis congestion:
Router(config)# interface Serial10/1/0:0
Router(config-if)# no ip address
Router(config-if)# encapsulation gsm-abis
Router(config-if)# load-interval 30
Router(config-if)# gsm-abis local 10.10.10.2 6661
Router(config-if)# gsm-abis remote 10.10.10.1 5553
Router(config-if)# gsm-abis congestion enable
Router(config-if)# no keepalive
Related Commands Command
gsm-abis congestion abate
gsm-abis congestion critical
gsm-abis congestion onset
gsm-abis jitter
OL-15667-03
gsm-abis congestion enable
Modification
This command was introduced.
Description
Sets the congestion abatement detection level at which the remote
router will stop suppressing timeslots because congestion has been
alleviated.
Defines the critical timeslots that are exempt from suppression
during congestion onset.
Sets the congestion onset detection level at which the remote router
will start suppressing all timeslots that are not defined as critical in
an effort to alleviate the congestion.
Sets the amount of transmit jitter delay for the GSM-Abis interface.
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
gsm-abis congestion enable
A-25