Mode Y-Cable - Cisco 3825 Software Configuration Manual

Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
standalone
To specify that the Cisco 3825 router is being used in a standalone configuration (which impacts the
relays on the VWIC/HWIC), use the standalone command in y-cable configuration mode. To use the
router in a redundant configuration, use the no form of this command.
Syntax Description This command has no arguments or keywords.
Defaults By default, the Cisco 3825 router is configured to be used in a redundant configuration (no standalone)
and the relays are open.
Command Modes Y-cable configuration
Command History Release
12.2(8)MC2
12.2(15)MC1
12.3(11)T
12.4(2)MR
Usage Guidelines Issuing the standalone command closes the relays on the VWICs/HWICs installed in the Cisco 3825
router.
Examples The following example closes the relays so that the router can be used as a standalone device.
Router# standalone
Related Commands Command

mode y-cable

standby use-interface
OL-15667-03
[no] standalone
Modification
This command was introduced.
This command was incorporated.
This command was incorporated.
This command was incorporated.
Description
Invokes y-cable mode.
Specifies the interfaces to be used for health and revertive interfaces.
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
standalone
A-119