Gsm-Abis Congestion Abate - Cisco 3825 Software Configuration Manual

Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference

gsm-abis congestion abate

Sets the congestion abatement detection level at which the remote router will stop suppressing timeslots
because congestion has been alleviated.
The abate detection level is defined as x milliseconds of continuous congestion abatement (that is, no
congestion indications). To set the abate detection, use the gsm-abis congestion abate Interface
configuration command.
Syntax Description ms
Defaults
There are no default settings or behaviors.
Command Modes
Interface configuration
Command History Release
12.4(2)MR
Examples
The following example shows how to the gsm-abis abate command is set at 250 ms:
Router(config)# interface Serial10/1/0:0
Router(config-if)# no ip address
Router(config-if)# encapsulation gsm-abis
Router(config-if)# load-interval 30
Router(config-if)# gsm-abis local 10.10.10.2 6661
Router(config-if)# gsm-abis remote 10.10.10.1 5553
Router(config-if)# gsm-abis congestion enable
Router(config-if)# gsm-abis congestion abate 250
Router(config-if)# no keepalive
Related Commands Command
gsm-abis congestion critical
gsm-abis congestion enable
gsm-abis congestion onset
gsm-abis jitter
OL-15667-03
gsm-abis congestion abate [ms]
Sets the number of milliseconds for the abate detection level.
Modification
This command was introduced.
Description
Defines the critical timeslots that are exempt from suppression
during congestion onset.
Sets the congestion detection algorithm to monitor the transmit
jitter buffer and to send congestion indicator signals to the remote
when congestion is detected.
Sets the congestion onset detection level at which the remote router
will start suppressing all timeslots that are not defined as critical in
an effort to alleviate the congestion.
Sets the amount of transmit jitter delay for the GSM-Abis interface.
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
gsm-abis congestion abate
A-21