Snmp-Server Enable Traps Ipran Alarm-Umts - Cisco 3825 Software Configuration Manual

Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference

snmp-server enable traps ipran alarm-umts

To provide information alarms associated with UMTS-Iub interfaces via Simple Network Management
Protocol (SNMP) notifications (traps) available on your system, use the snmp-server enable traps
ipran alarm-umts command in global configuration mode. To disable ipran alarm-umts notifications,
use the no form of this command.
This statement controls the generation of the cisco IpRanBackHaulUmtsAlarm notification from the
CISCO-IP-RAN-BACKHAUL-MIB.
Syntax Description This command has no arguments or keywords.
Defaults
This command is disabled by default. No notifications are sent.
Command Modes Global configuration
Command History Release
12.4(2)MR1
Examples
The following is an example of the output generated by this command.
Router(config)# snmp-server enable traps ipran alarm-umts
Related Commands Command
snmp-server enable traps
ipran alarm-gsm
snmp-server enable traps
ipran util
snmp-server enable traps
ipran
OL-15667-03
snmp-server enable traps ipran alarm-umts
no snmp-server enable traps ipran alarm-umts
Modification
This command was introduced.
Description
Provides information alarms associated with GSM-Abis interfaces.
Provides information on backhaul utilization.
Enables all notifications.
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
snmp-server enable traps ipran alarm-umts
A-117