Cisco 3825 Software Configuration Manual page 245

Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
Usage Guidelines The show xconnect all command can be used to display, sort, and filter basic information about all
xconnect attachment circuits and PWs.
You can use the show xconnect all command output to help determine the appropriate steps to
troubleshoot an xconnect configuration problem. More specific information about a particular type of
xconnect can be displayed using the commands listed in the Related Commands table.
Examples The following example shows show xconnect all command output in the brief (default) display format.
The sample output shows information about the interfaces and VCs that have been configured to
transport various Layer 2 packets on the router:
Router# show xconnect all
Legend: XC ST=Xconnect State, S1=Segment1 State, S2=Segment2 State
UP=Up, DN=Down, AD=Admin Down, IA=Inactive, NH=No Hardware
XC ST
------+---------------------------------+--+---------------------------------+--
UP
UP
IA pri ac
UP sec ac
Table A-6
Table A-6
Field
XC ST
Segment1
or
Segment2
OL-15667-03
Segment 1
ac Et0/0(Ethernet)
ac Et1/0.1:200(Eth VLAN)
Et1/0.2:100(Eth VLAN)
Et1/0.2:100(Eth VLAN)
describes the significant fields shown in the display.
show xconnect all Field Descriptions
Description
• State of the xconnect attachment circuit or PW. Valid states are:
UP—The xconnect attachment circuit or PW is up. Both segment 1 and
•
segment 2 must be up for the xconnect to be up.
• DN—The xconnect attachment circuit or PW is down. Either segment 1,
segment 2, or both segments are down.
IA—The xconnect attachment circuit or PW is inactive. This state is valid
•
only when PW redundancy is configured.
NH—One or both segments of this xconnect no longer has the required
•
hardware resources available to the system.
Information about the type of xconnect, the interface type, and the IP address the
segment is using. Types of xconnects are:
ac—Attachment circuit.
•
pri ac—Primary attachment circuit.
•
• sec ac—Secondary attachment circuit.
• mpls—Multiprotocol Label Switching.
• l2tp—Layer 2 Tunnel Protocol.
S1 Segment 2
UP mpls 10.55.55.2:1000
UP mpls 10.55.55.2:5200
UP ac Et2/0.2:100(Eth VLAN)
UP mpls 10.55.55.3:1101
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
show xconnect all
S2
UP
UP
UP
UP
A-113