Cisco 3825 Software Configuration Manual page 112

Configuration Sequence
Step 16 Specify the percent of the interface bandwidth allocated for LLQ.
Router(config-if)# max-reserved-bandwith percent
Where percent is the percent of interface bandwidth allocated for LLQ.
For example, the following command specifies the interface bandwidth allocated for LLQ as 100%:
Router(config-if)# max-reserved-bandwidth 100
Assign the QoS boilerplate to the multilink interface.
Step 17
Router(config-if)# service-policy output policy_name
Where policy_name is LLQ.
For example, the following command assigns the QoS boilerplate to the multilink interface policy name
LLQ:
Router(config-if)# service-policy output llq-policy
Set the size of the output queue.
Step 18
Router(config-if)# hold-queue size in | out
Where:
size— Number of packets held in the queue.
•
in | out—Direction of packets being held, either input or output.
•
For example, the following command sets the size of the queue for the outbound packets at 50:
Router(config-if)# hold-queue 50 out
Note
Enable TCP header compression.
Step 19
Router(config-if)# ip tcp header-compression keyword
For example, the following command enables IETF-Format as the header compression:
Router(config-if)# ip tcp header-compression ietf-format
Note In the previous procedure, PVC 2/1 of ATM0/0/0 and ATM0/0/1 will go to the priority queue and PVC
2/2 of ATM0/0/0 and ATM0/0/1 will be considered the best effort traffic and will go to the Weighted Fair
Queue.
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
4-54
Chapter 4 Configuring the Cisco 3825 Mobile Wireless Edge Router in a RAN-O Solution with the Command-Line
Specify a hold-queue limit. The limit needs to be greater than the hold-queue depth that is
defined on the default class (see the
information).
"Creating a Class Map" section on page 4-47 for more
OL-15667-03