Verifying The Hostname And Password - Cisco 3825 Software Configuration Manual

Chapter 4 Configuring the Cisco 3825 Mobile Wireless Edge Router in a RAN-O Solution with the Command-Line
To configure a hostname and to set an encrypted password, follow these steps:
Enter enable mode.
Step 1
Router> enable
The Password prompt appears. Enter your password.
Password: password
You have entered the enable mode when the prompt changes to
Step 2 Enter global configuration mode.
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
You have entered global configuration mode when the prompt changes to
Router(config)#
Change the name of the router to a meaningful name. Substitute your hostname for
Step 3
Router(config)# hostname Router
Router(config)#
Enter an enable secret password. This password provides access to the privileged EXEC mode. When
you type enable at the EXEC prompt (
configuration mode. Enter your secret password.
Router(config)# enable secret secret password
Exit back to global configuration mode.
Step 4
Router(config)# exit

Verifying the Hostname and Password

To verify that you have correctly configured the hostname and password, follow these steps
Enter the show config command:
Step 1
Router# show config
Using 1888 out of 126968 bytes
!
version XX.X
.
.
.
!
hostname Router
!
enable secret 5 $1$60L4$X2JYOwoDc0.kqa1loO/w8/
.
.
.
OL-15667-03
), you must enter the enable secret password to access the
Router>
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
Configuration Sequence
.
Router#
Router(config)#.
Router
.
4-7