Umts-Iub Set Dscp - Cisco 3825 Software Configuration Manual

umts-iub set dscp

umts-iub set dscp
To mark a packet by setting the differential services code point (DSCP) for UMTS-Iub value for the
backhaul packet including the peering and data generated from the shorthaul, use the umts-iub set dscp
Interface configuration command.
Use this command when configuring UMTS shorthaul interfaces.
Note
Syntax Description value
Defaults
There are no default settings or behaviors.
Command Modes Interface configuration
Command History Release
12.4(4)MR
Examples
The following example shows how to configure the parameters:
Router(config)# interface ATM0/2/0
Router(config-if) atm umts-iub
Router(config-if) umts-iub set dscp [value]
Related Commands Command
umts-iub set peering dscp
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
A-128
umts-iub set dscp value
A number from 0 to 63 or hex value that sets the UMTS-Iub DSCP value.
Modification
This command was introduced.
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
Description
This command overwrites the interface default value defined in the
umts-iub set dscp value and is used to tag peering backhaul packet.
OL-15667-03