Cisco 3825 Software Configuration Manual page 231

Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
Table A-5
Field
Tunnel label
SSO Descriptor
local label
SSM
segment/switch IDs
PWID
packet totals
byte totals
packet drops
Related Commands Command
show mpls l2transport
summary
OL-15667-03
show mpls l2transport vc Field Descriptions (continued)
Description
An IGP label used to route the packet over the MPLS backbone to the
destination router with the egress interface. The first part of the output displays
the type of label. The second part of output displays the route information.
The tunnel label information can display any of the following states:
imp-null—The provider (P) router is absent and the tunnel label is not to be
•
used. Alternatively, imp-null can signify traffic engineering tunnels
between the PE routers.
• unassigned—The label has not been assigned.
• no route—The label is not in the routing table.
• no adjacency—The adjacency for the next hop is missing.
not ready, no route—An IP route for the peer does not exist in the routing
•
table.
• not ready, not a host table—The route in the routing table for the remote
peer router is not a host route.
• not ready, Cisco Express Forwarding disabled—Cisco Express Forwarding
is disabled.
not ready, LFIB disabled—The MPLS switching subsystem is disabled.
•
not ready, label forwarding information base (LFIB) entry present—The
•
tunnel label exists in the LFIB, but the VC is down.
Identifies the VC for which the information was checkpointed.
The value of the local label that was checkpointed (that is, sent on the active
Route Processor [RP], and received on the standby RP).
The IDs used to refer to the control plane and data plane contexts for this VC.
This data is not for customer use but for Cisco personnel for troubleshooting
purposes. When the source specific multicast (SSM) IDs are followed by the
word "used," the checkpointed data has been successfully sent and not released.
The PW ID used in the data plane to correlate the switching context for the
segment mentioned with the MPLS switching context. This data is not for
customer use but for Cisco personnel for troubleshooting purposes.
Number of packets sent and received. Received packets are those AToM packets
received from the MPLS core. Sent packets are those AToM packets sent to the
MPLS core. This does not include dropped packets.
Number of bytes sent and received from the core-facing interface, including the
payload, control word if present, and AToM VC label.
Number of dropped packets.
Description
Displays summary information about VCs that have been enabled to
route AToM Layer 2 packets on a router.
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
show mpls l2transport vc
A-99