Umts Remote - Cisco 3825 Software Configuration Manual

umts remote

umts remote
To configure local ip address for the atm subinterfaces, use the umts remote Sub-Interface configuration
command. This command is used when you want to off load one or more PVC's traffic from a physical
ATM shorthaul to go over alternate backhaul. For each alternate backhaul, you need to create a logical
shorthaul by creating an atm subinterface. Traffic for the PVCs configured under this logical shorthaul
will go through the corresponding alternate backhaul.
Syntax Description ip-address
Command Modes Sub-Interface configuration
Command History Release
12.4(4)MR
Examples The following example illustrates the use umts remote command.
Router(config)# interface ATM0/2/0
Router(config-if)# atm umts-iub
Router(config-subif)# atm umts
Router(config-subif)# umts remote 10.10.10.1 5502
The port number will be inherited from the base ATM interfaces's remote port number.
Note
Related Commands Command
atm umts
umts local [ip-address]
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
A-132
umts remote [ip-address]
The IP address for the entry you wish to establish.
Modification
This command was introduced.
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
Description
This command enables the UMTS mode for alternate backhaul.
This command configures the remote IP address for alternate
backhaul.
OL-15667-03