Cisco 3825 Software Configuration Manual page 108

Mobile wireless edge router
Table of Contents

Advertisement

Configuration Sequence
Step 7
To set the DSCP value used as the interface default DSCP value to tag the backhaul packet, use the
following command:
Router(config-if)# umts-iub set dscp value
Where value is a number chosen to represent that packet of traffic.
For example, the following command specifies the number 16 for the packet of traffic for the umts-iub
interface:
Router(config-if)# umts-iub set dscp 16
Perform Steps 5 through 7 to set another PVC 2/2 with a umts-iub interface DSCP of 8.
Step 8
Step 9
To overwrite the previous PVC 2/1 with a umts-iub interface DSCP of 16, use the following command:
Router(config-if)# umts-iub set dscp value
Where value is a number chosen to represent that packet of traffic.
For example, the following command overwrites the number 16 for the packet of traffic for the umts-iub
interface:
Router(config-if)# umts-iub set dscp 16
To configure the local parameters required to establish an IP/UDP backhaul connection, enter the
Step 10
following command including the IP address and port you want to establish the IP/UDP backhaul
connection from.
Router(config-if)# umts-iub local ip-address port
For example, the following command configures the umts-iub local interface with an IP address and port
of 20.20.20.21 6666:
Router(config-if)# umts-iub local 20.20.20.21 6666
Step 11
To configure the remote parameters required to establish an IP/UDP backhaul connection, enter the
following command including the IP address and port you want to establish the IP/UDP backhaul
connection from.
Router(config-if)# umts-iub remote ip-address port
For example, the following command configures the umts-iub remote interface with an IP address and
port of 20.20.20.20 6666:
Router(config-if)# umts-iub remote 20.20.20.20 6666
Perform Steps 1 to 7 for ATM0/0/1 with a UMTS DSCP of 8.
Step 12
To overwrite the previous PVC 2/1 with a umts-iub interface DSCP of 16, use the following command:
Step 13
Router(config-if)# umts-iub set dscp value
Where value is a number chosen to represent that packet of traffic.
For example, the following command overwrites the number 16 for the packet of traffic for the umts-iub
interface:
Router(config-if)# umts-iub set dscp 16
To configure the local parameters required to establish an IP/UDP backhaul connection, enter the
Step 14
following command including the IP address and port you want to establish the IP/UDP backhaul
connection from.
Router(config-if)# umts-iub local ip-address port
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
4-50
Chapter 4
Configuring the Cisco 3825 Mobile Wireless Edge Router in a RAN-O Solution with the Command-Line
OL-15667-03

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents