Cisco 3825 Software Configuration Manual page 167

Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
idle-pattern
To specify the data pattern transmitted on the T1/E1 when missing packets are detected on the PWE3
circuit, use the idle-pattern command in CEM configuration mode.
Syntax Description
pattern
Defaults Default idle-pattern is 0xFF.
Command Modes CEM circuit configuration
Command History Release
12.4(12)MR2
Usage Guidelines The idle-pattern data is sent to replace the data from missing packets.
Examples The following example illustrates the use of the idle-pattern command:
Router# config t
Router(config)# interface cem 0/0/0
Router(config-if)# no ip address
Router(config-if)# cem 0
Router(config-if-cem)# idle-pattern 0x55
Router(config-if-cem)# xconnect 10.10.10.10 200 encapsulation mpls
Router(config-if-cem-xconn)# exit
Router(config-if-cem)# exit
Router(config-if)# exit
Router(config)# exit
Related Commands Command
cem
cem class
class cem
OL-15667-03
idle-pattern [pattern]
no idle-pattern
An 8-bit hexadecimal number that is transmitted as the idle pattern.
Modification
This command was introduced.
Description
Enters circuit emulation configuration mode.
Applies the CEM interface parameters defined in the given
<cem-class-name> to the circuit.
Configure's CEM interface parameters in a class that's applied to
CEM interfaces together in the global configuration mode.
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
idle-pattern
A-35