Cisco 3825 Software Configuration Manual page 197

Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
pseudowire-class
To specify the name of a Layer 2 pseudowire-class and enter pseudowire-class configuration mode, use
the pseudowire-class command in the global configuration mode.
Syntax Description pw-class-name
Defaults
No pseudowire-class is defined.
Command Modes Global configuration
Command History Release
12.0(23)S
12.3(2)T
12.4(12)MR2
Usage Guidelines The pseudowire-class command configures a pseudowire-class template that consists of configuration
settings used by all attachment circuits bound to the class. A pseudowire-class includes the following
configuration settings:
•
•
•
•
•
After entering the pseudowire-class command, the router switches to pseudowire-class configuration
mode where PW settings can be configured.
Examples The following example shows how to enter pseudowire-class configuration mode to configure a PW
configuration template named "ether-pw":
Router# config t
Router(config)# pseudowire-class l2tp
Router(config-pw-class)# encapsulation l2tpv3
Router(config-pw-class)# exit
Router(config)# exit
OL-15667-03
pseudowire-class [pw-class-name]
(Required) The name of a Layer 2 pseudowire-class.
Modification
This command was introduced.
This command was integrated into Cisco IOS Release 12.3(2)T.
This command was integrated into Cisco IOS Release 12.4(12)MR2.
Data encapsulation type
Control protocol
Sequencing
IP address of the local Layer 2 interface
Type of service (ToS) value in IP headers
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
pseudowire-class
A-65