Cisco 3825 Software Configuration Manual page 84

Configuration Sequence
For example, the following command configures the clock source for the E1 controller:
Router(config-controller)# clock source internal
When you are using the clock source {line [primary] | internal} command to change the configuration
Note
of an installed card, you must enter the no clock source {line [primary] |internal} command first. Then
enter the clock source {line {primary] | internal} command for the new configuration information.
Exit the controller configuration mode.
Step 5
Router(config-controller)# exit
Configure the network clock support for the Cisco 2-port T1/E1-RAN interface card.
Step 6
Router(config)# network-clock-participate wic number
Where number is the slot number of the Cisco 2-port T1/E1-RAN interface card which is installed on
the Cisco 3825 router.
For example, the following command enables the Cisco 2-port T1/E1-RAN interface card in logical
slot 2 (physical slot HWIC1) of the Cisco 3825 router to use the network clock for its timing:
Router(config)# network-clock-participate wic 1
Configure the network clock support for the AIM for ATM card interface.
Step 7
Router(config)# network-clock-participate aim number
Where number is the slot number of the AIM for ATM card interface installed in the Cisco 3825 router.
For example, the following command enables the AIM for ATM card interface in physical slot 1 of the
Cisco 3825 router to use the network clock for its timing:
Router(config)# network-clock-participate aim 1
To configure the UMTS-Iub interface, first specify the ATM interface by entering the interface
Step 8
configuration mode.
Router(config)# interface ATM slot/subslot/port
Where:
slot—Specifies the slot number of the VWIC/HWIC previously assigned to the AIM for ATM card.
•
subslot—Specifies the subslot number of the VWIC/HWIC previously assigned to the AIM for ATM
•
card.
port—Specifies the port on the VWIC/HWIC previously assigned to the AIM for ATM card.
•
For example, the following command configures the VWIC/HWIC in logical slot 0 (physical slot 0),
subslot 0, port 1 located on the motherboard of the Cisco 3825 router to be used for ATM traffic:
Router(config)# interface ATM0/2/0
Router(config-if)#
Note
To create an ATM path on the UMTS Iub interface, enter the following command:
Step 9
Router(config-if)# atm umts-iub
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
4-26
Chapter 4 Configuring the Cisco 3825 Mobile Wireless Edge Router in a RAN-O Solution with the Command-Line
To see a list of the configuration commands available to you, enter ? at the prompt or press the
Help key while in the configuration mode.
OL-15667-03