Umts-Iub Backhaul-Oam - Cisco 3825 Software Configuration Manual

umts-iub backhaul-oam

umts-iub backhaul-oam
To configure the local parameters required to provide OAM cells received on the UMTS ATM interface
to be sent across the backhaul, use the umts-iub backhaul-oam Interface configuration command. To
not transport the OAM cells across the backhaul, use the no form of this command.
When using the no form of the command, the end devices may only use OAM loopback cells. I.610 OAM
Note
messages are not supported by the Cisco 3825 router; therefore, if you are using this mode, OAM cells
should be backhauled.
Additionally, the pvc-oam manage Interface configuration for ATM-VC commands at the PVC
configuration level should be enabled for UMTS PVCs on the Cisco 3825 router. These PVCs will
respond to OAM cells if the no version of the umts-iub backhaul-oam command is used.
Syntax Description This command has no arguments or keywords.
Defaults There are no default settings or behaviors.
Command Modes
Interface configuration
Command History Release
12.4(2)MR
Examples The following example shows how to configure the local parameters:
Router(config)# interface ATM0/2/0
Router(config-if) atm umts-iub
Router(config-if) umts-iub local 10.10.10.2 5504
Router(config-if) umts-iub backhaul-oam
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
A-122
umts-iub backhaul-oam
Modification
This command was introduced.
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
OL-15667-03