Table of Contents
Advertisement
Troubleshooting
To
run
the self-tests
To run the self-tests
Self-tests identify the correct operation of major functional areas of the instrument. You can
run all self-tests without accessing the interior of the instrument.
If
a self-test fails, the
troubleshooting flowcharts instruct you to change a part of the instrument.
These procedures assume the files on the PV disk have been copied to the /SYSTEM
subdirectory on the hard disk drive. If they have not already been copied, insert the PV disk
in the flexible disk drive before starting this procedure.
1 If you just did the power-up self-tests, go to step 2.
If you did not just do the power-up self-tests, disconnect all inputs, then turn on the
power switch. Wait until the power-up tests are complete.
2 Press the System key, then select the field next to System. Then, select Test in the
pop-up menu.
liPID S;;lung,
(
~rinl
I
Hord
[li~1
EHernal 110
PrInler
I
SVM50L UTlUH
I
L:J
;==t-_,_,_e!:_'"_"_"_"_'_-r"'-'
3 Select the box labeled
Load
Test System, then select Continue.
4 Press the System key, then select the field next to Sys PV. Select System Test to
access the system tests.
Sys PV
)
Connecte
1 To'
10" l'!rna I 110
Ulllllles
:~
PS~}~
Setllngs
J
HPIB
S.eltlng~
5-18
Advertisement
Table of Contents
