HP 1660E Series Service Manual page 158

Troubleshooting
To run the self-tests
13 Select Board Tests, then select Run. When the Board Tests are finished, select Done.
Th15 tcst Checl:$ the clOCk generatIon
Clfeul
ts
On (lIe bOUd.
Olld tilt' d"[il
<lod clock compMDlofs.
(
(
(
(
Boord tcst
rUO$
,
fllllure5
14 Select Data Input Inspection. All lines should show activity. Select Done to exit the
Data Input Inspection.
( AllOly PV)
Pod 1'12 ttUUtUU:;ltf n
Pod I'll nnnnann;: Jl
Pod At>
Pod 1'15
Pod A4
Pod A3
nu;uuUUUt
uuannnnn
u:u:n:;u;;;;
M:
I
;nn:;;:;;;;;;; L;
Pod All unnnnnnn P:
Pod A7
n:;n~nnn~n
Nt
flll lilies should sho>! octivlly. An,1 llllCS IH UWUI
Ilcttvll\llJre not lunCllonlng cnrrectlg. ~Ild should
not be used 1n 0 meosurement.
If you have an HP 1660E-series logic analyzer (no oscilloscope or pattern generator), go to
step 19. If you have an HP 1660EP-series logic analyzer, go to step 18.
If
you have an
HP 1660ES-series logic analyzer, continue with step 15.
15 Select Analy PV, then select Scope PV in the pop up menu. Select Functional Tests.
16 Select one of the Scope PV tests.
You can run all of the tests at one time by selecting All Tests, or you can run each test
individually. For this example, select Data Memory Test.
FLJnt[JimOI Tests
O"t" nemory TeSl
SI.llllr. WJTE5TE:[l
Tlmeb<,>Si' Tost
Status UNTESTE(i
AID T~5l
StiltliS UNTESTED
[lIA Test
Slo[U5 UrnESTE()
TrIgger Tos\
S l<'l IUS WHESTE:[o
Wi'l T~st
SlilltlS UNTESTE[>
PLEASE DISCONNECT ALL INPUTS
I
All Tests
I
5-22