Diskette Cable; Removing The Diskette Cable - Sun Microsystems Ultra 1 Creator Series Service Manual

4. Replace the system unit cover.
See Section 7.3 "Replacing the Cover" on page 7-3.
5. Power-on the system.
See Section 6.1 "Powering On the System" on page 6-1.
8.4

Diskette Cable

To remove and replace the diskette cable, proceed as follows.
8.4.1

Removing the Diskette Cable

Note – If the system is configured with a CD-ROM drive or a tape drive, complete
Step 1. If the system is not configured with a CD-ROM drive or a tape drive, skip
Step 4 and proceed to Step 5.
1. Power-off the system.
See Section 6.2 "Powering Off the System" on page 6-2.
2. Remove the system unit cover.
See Section 7.1 "Removing the Cover" on page 7-1.
Caution – Use proper ESD grounding techniques when handling components. Wear
!
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing it on any surface.
3. Attach the wrist strap.
See Section 7.2 "Attaching the Wrist Strap" on page 7-2.
4. Remove the drive bracket as follows (
a. Remove the two mounting screws securing the drive bracket to the chassis.
b. Remove the DC harness from the clip located on the drive bracket.
c. Push the drive bracket toward the disk drive bay; gently flip the drive bracket
over.
d. Place the drive bracket on top of the disk drive bay.
8-14 Ultra 1 Creator Series Service Manual • August 1996
and
FIGURE 8-11 FIGURE 8-12
):