Peripheral Power Cable; Removing The Peripheral Power Cable - Sun Microsystems Ultra 1 Creator Series Service Manual

Caution – Each drive slot has a unique SCSI target address (lower drive slot is
target address 0, upper drive slot is target address 1). Make note of the drive slot for
each disk drive. Installing a disk drive into the incorrect drive slot could cause file
system or system boot problems.
6. Replace the disk drive assembly(ies).
See Section 9.4.2 "Replacing a Diskette Drive" on page 9-14.
7. Replace the bracket into the chassis.
See Section 9.2.2 "Replacing the Chassis Bracket" on page 9-7.
8. Detach the wrist strap.
9. Replace the system unit cover.
See Section 7.3 "Replacing the Cover" on page 7-3.
10. Power-on the system.
See Section 6.1 "Powering On the System" on page 6-1.
8.6

Peripheral Power Cable

To remove and replace the peripheral power cable, proceed as follows.
8.6.1

Removing the Peripheral Power Cable

1. Power-off the system.
See Section 6.2 "Powering Off the System" on page 6-2.
2. Remove the system unit cover.
See Section 7.1 "Removing the Cover" on page 7-1.
Caution – Use proper ESD grounding techniques when handling components. Wear
!
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing it on any surface.
3. Attach the wrist strap.
See Section 7.2 "Attaching the Wrist Strap" on page 7-2.
Chapter 8 Major Subassemblies 8-23