Dsimm; Figure 10-20 Securing The Ffb Card Into The Chassis - Sun Microsystems Ultra 1 Creator Series Service Manual

FFB card
FIGURE 10-20
10.5

DSIMM

To remove and replace a DSIMM, proceed as follows.
Caution – DSIMMs consist of electronic components that are extremely sensitive to
!
static electricity. Ordinary amounts of static electricity from clothing or work
environment can destroy the DSIMM.
Caution – When removing a DSIMM an identical replacement is required. The
replacement DSIMM must be inserted into the same socket as the removed DSIMM.
!
The Ultra 1 Creator series system must have at least two identical DSIMMs installed
in paired sockets of any DSIMM bank.
locations.
Securing the FFB Card Into the Chassis
Chapter 10
Card retainer (2)
identifies DSIMM installation
TABLE 10-2
System Board and Component Replacement 10-23