Sun Microsystems Ultra 1 Creator Series Service Manual page 106

FIGURE 8-24
7. Use the needle-nose pliers to disconnect the speaker/LED cable from the speaker
(
FIGURE 8-25
8. Remove any SBus card(s).
See Section 10.3.1 "Removing an SBus Card" on page 10-14.
9. Disconnect the speaker/LED cable from the system board at J2001 (
10. Pull the speaker/LED cable from the chassis, removing it from the backplane
assembly clips.
8-32 Ultra 1 Creator Series Service Manual • August 1996
Flat side
Removing/Replacing the Speaker/LED Cable
).
LED
Speaker/LED cable
Black wire
Cable clip (2)
).
FIGURE 8-26