Replacing A Disk Drive - Sun Microsystems Ultra 1 Creator Series Service Manual

7. Hold the drive handle and pull it out to remove the disk drive from the chassis.
Note – The disk drive rear connector is disconnected when the disk drive is ejected.
8. Place the disk drive on an antistatic surface.
9.1.2

Replacing a Disk Drive

Caution – Each drive slot has a unique SCSI target address (lower drive slot is
!
target address 0, upper drive slot is target address 1). Make note of the drive slot for
each disk drive. Installation of a disk drive into an incorrect drive slot can cause file
system or system boot problems.
Caution – Use proper ESD grounding techniques when handling components. Wear
!
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing it on any surface.
1. With the drive handle open, press on the disk drive end and insert the disk drive
into the chassis; connect the disk drive to the backplane assembly (
2. Close the drive handle until the release latch clicks and the handle is securely
latched to the chassis.
Note – The drive handle does not latch if the disk drive is not properly seated into
the slot.
FIGURE 9-3
Chapter 9 Storage Devices
).
9-3