Figure 10-4 Removing Sbus Filler Panels From The Back Panel - Sun Microsystems Ultra 1 Creator Series Service Manual

1. Remove the SBus filler panel(s) from the replacement system board as follows:
a. Squeeze the filler panel bottom locking tabs to unhook them from the back
panel (
FIGURE 10-4
Removing SBus Filler Panels from the Back Panel
FIGURE 10-4
b. Pull the filler panel away from the back panel.
Caution – Handle the system board by the back panel or by the edges only.
!
2. Prepare to install the system board as follows
(
FIGURE 10-5
a. Install the front card guide.
b. Insert the vertical tab on the far left of the front card guide into the slot at the
front edge of the system board.
c. Swing the card guide forward until the registration pin on the far right side of
the card guide clicks into engagement with the motherboard front edge slot.
Note – The card guide will flex enough to allow the vertical tab to fit into its slot
and hold the card guide in position.
).
and ):
FIGURE 10-6
Chapter 10
Back panel
Locking tab (2)
System Board and Component Replacement
SBus filler panel
10-5