Figure 8-2 Replacing The Power Supply - Sun Microsystems Ultra 1 Creator Series Service Manual

Note – Ensure that the hooks located on the chassis base engage with the cutouts
located on the bottom of the power supply.
FIGURE 8-2
3. Tighten the captive screw securing the power supply to the back panel.
4. Connect the power supply as follows (
a. Connect the DC connector to the peripheral power cable at P1.
b. Route and insert the DC harness through the clip on the drive bracket.
c. Connect the power supply connector to the system board at J2603.
d. Connect the power supply connector to the system board at J2601.
5. Detach the wrist strap.
6. Replace the system unit cover.
See Section 7.3 "Replacing the Cover" on page 7-3.
8-4 Ultra 1 Creator Series Service Manual • August 1996
Power supply
Mounting hook (3)
Back panel
Replacing the Power Supply
System board
):
FIGURE 8-3
Chassis