Diskette Drive; Removing A Diskette Drive - Sun Microsystems Ultra 1 Creator Series Service Manual

Note – If the system is configured with a diskette drive, the diskette drive is
assembled on the chassis bracket.
3. Replace the four screws securing the CD-ROM drive or the 4-mm/8-mm tape drive
to the chassis bracket.
4. Replace the chassis bracket.
See Section 9.2.2 "Replacing the Chassis Bracket" on page 9-7.
5. Detach the wrist strap.Replace the system unit cover.
See Section 7.3 "Replacing the Cover" on page 7-3.
6. Power-on the system.
See Section 6.1 "Powering On the System" on page 6-1.
9.4

Diskette Drive

To remove and replace the diskette drive, proceed as follows.
9.4.1

Removing a Diskette Drive

1. Power-off the system.
See Section 6.2 "Powering Off the System" on page 6-2.
2. Remove the system unit cover.
See Section 7.1 "Removing the Cover" on page 7-1.
Caution – Use proper ESD grounding techniques when handling components. Wear
! an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing it on any surface.
3. Attach the wrist strap.
See Section 7.2 "Attaching the Wrist Strap" on page 7-2.
4. Remove the chassis bracket.
See Section 9.2.1 "Removing the Chassis Bracket" on page 9-5.
9-12 Ultra 1 Creator Series Service Manual • August 1996