Figure 10-19 Seating An Ffb Card Into The Upa Socket - Sun Microsystems Ultra 1 Creator Series Service Manual

3. At an angle, lower the FFB card into the chassis over the UPA socket.
4. Hook the FFB card backplate under the chassis back panel tabs. Ensure that the
FFB card backplate is visible through the back panel slot.
5. Carefully press both corners of the FFB card evenly to seat the FFB card connector
into the UPA socket (
Caution – Avoid applying force to one end or one side of the FFB board or the
connector pin may be damaged.
FIGURE 10-19
6. Push the card retainer onto the board (
7. Detach the wrist strap.
8. Replace the unit cover.
See Section 7.3 "Replacing the Cover" on page 7-3.
9. Connect the video cable to the 13W3 video connector.
10. Power-on the system.
See Section 6.1 "Powering On the System" on page 6-1.
10-22 Ultra 1 Creator Series Service Manual • August 1996
FIGURE 10-19
FFB
card
Seating an FFB Card Into the UPA Socket
).
UPA socket
).
FIGURE 10-20