Disk drive
bay
SCSI cable
Diskette cable
Replacing the Peripheral Power Cable Connection
FIGURE 8-20
2. Route the peripheral power cable through the backplane assembly cable clips
(
).
FIGURE 8-19
3. Position and secure the drive bracket as follows (
a. Position the drive bracket in the chassis; slide the drive bracket toward the
opening in the chassis side.
b. Connect the DC harness to the peripheral power cable at P1.
c. Route the DC harness through the drive bracket clip.
d. Replace the two screws securing the drive bracket to the chassis.
P2
P3
P4
):
FIGURE 8-21
Chapter 8
Major Subassemblies
8-27