Replacing A Nvram/Tod - Sun Microsystems Ultra 1 Creator Series Service Manual

FIGURE 10-11
10.2.2

Replacing a NVRAM/TOD

Caution – Use proper ESD grounding techniques when handling components. Wear
!
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing it on any surface.
1. Position the replacement NVRAM/TOD and carrier on the system board
(
FIGURE 10-11
2. Carefully insert the NVRAM/TOD and carrier into the socket.
Note – The carrier is keyed so the NVRAM/TOD can be installed only one way.
3. Push the NVRAM/TOD into the carrier until properly seated.
4. Detach the wrist strap.
5. Replace the unit cover.
See Section 7.3 "Replacing the Cover" on page 7-3.
NVRAM/TOD
NVRAM/TOD
).
Chapter 10 System Board and Component Replacement
System board
10-13