Figure 8-17 Removing The Drive Bracket - Sun Microsystems Ultra 1 Creator Series Service Manual

4. Disconnect the DC harness as follows (Figure 8-17):
a. Remove the two screws securing the drive bracket to the chassis.
b. Remove the DC harness from the drive bracket clip.
c. Disconnect the DC harness from the peripheral power cable at P1.
FIGURE 8-17
5. Position the drive bracket as follows 8-18:
a. Push the drive bracket toward the disk drive bay.
b. Gently flip the drive bracket over and set on top of the disk drive bay.
c. Disconnect the peripheral power cable from the peripherals and the fan
(
TABLE 8-1
6. Remove the peripheral power cable from the cable clips on the backplane
assembly.
8-24 Ultra 1 Creator Series Service Manual • August 1996
P1
Clip
Removing the Drive Bracket
).
Screw (2)