1. Route the SCSI cable under the three cable clips in the base of the chassis and
through the opening near the front edge of the system board (
2. Connect the SCSI cable to J2602 on the system board.
3. Position the backplane assembly on the disk drive bay so the backplane assembly
slots sit on the tabs (
4. Replace the two screws securing the backplane assembly to the bracket.
FIGURE 8-16
5. Connect the following (
a. The peripheral power cable (P4) to the backplane assembly connector marked
PWR.
b. The diskette cable (if present) to the backplane assembly connector marked
FLOPPY.
8-22
Ultra 1 Creator Series Service Manual • August 1996
FIGURE 8-16
Tab (4)
SCSI backplane slot
(4 places)
Replacing the SCSI Backplane
FIGURE 8-14
).
Disk drive bay
Screw (2)
Diskette cable
):
).
FIGURE 8-15
P4